Quick and easy setup video of the W100 or W100P controller

WCTW100 Basic Programming

Transcript (auto-generated):

Step one: select a configure sensor type for contacting conductivity inputs enter configure enter then the down key until you get to contact in conductivity check it off then go back to the home menu

Step two: select and configure the bleed relay for on/off setpoint outputs enter and then configure you want to make sure the HOA settings are set for auto and then the down arrow key until you get to the mode press ENTER on offset point and then okay and then the HOME key again

Step three: you assign the conductivity sensor to the bleed relay hit the relay the output and then the relay enter configure input get enter and then down to choose the conductivity sensor okay then you can go back to the home

Did this answer your question?