Supplyline Industrial sells and supports the complete line of Meunier Technologies DICE Dosing & Chemical Feed Systems
Call or text Supplyline for 24/7 sales & support
Before You Begin
Before assembling the DICE™ Panel, make sure you have read the installation instructions carefully. This guide will walk you through the steps, but it's always good to familiarize yourself with the manufacturer's directions.
Follow along with the video tutorial or click the timestamp next to any step to jump to that point in the video.
Assembling the DICE™ Panel
Tip: Tap the ▶ Step #
to expand or collapse more detailed instructions
Step 1: Unbox and Check the Components
Step 1: Unbox and Check the Components
Begin by unboxing the DICE™ Panel components. Ensure that you have all the necessary parts: an upper back panel, lower back panel, shelf, two shelf supports, two back panel attachment tabs, two shelf attachment tabs, six 1/2 inch long standoffs, three 1/8 inch long DICE™ spacers, three DICE™ rear nut tabs, twenty-four 3/4 inch long assembly screws, and three 3/8 inch long assembly screws.
Step 2: Assemble the Shelf Supports
Step 2: Assemble the Shelf Supports
Insert the back panel attachment tab and the shelf attachment tab onto each of the shelf supports. Ensure the tabs are fully inserted and that the smaller holes are facing outward.
Step 3: Attach Shelf Supports to the Shelf
Step 3: Attach Shelf Supports to the Shelf
Push the pre-assembled shelf supports into the pockets on the bottom surface of the shelf. Secure them with six of the 3/4 inch long assembly screws.
Step 4: Connect the Back Panels to the Shelf Assembly
Step 4: Connect the Back Panels to the Shelf Assembly
Align the lower and upper back panels with their front facing up. Insert the shelf assembly into the six openings of the back panels. Secure them with eighteen 3/4 inch long assembly screws.
Step 5: Attach the Standoffs
Step 5: Attach the Standoffs
Insert the half-inch-long standoffs on the back of the upper and lower back panels. If necessary, use a plastic hammer to press fit the standoffs into the dedicated holes.
Step 6: Install the DICE™ Spacers and Rear Nut Tabs
Step 6: Install the DICE™ Spacers and Rear Nut Tabs
Choose your desired DICE™ configuration. Insert the 1/8 inch long DICE™ spacers into the holes on the front of the upper back panel, following the pattern of the chosen configuration. Then install the DICE™ rear nut tabs into the pre-defined pockets and secure them with three 3/8 inch long assembly screws.
✅ With this, your DICE™ Panel assembly is now complete. If you have any questions or need additional support, don't hesitate to reach out to our support team.
Still have Questions?
Give us a call at 484-544-0506