All Collections
Peabody Engineering Support
When I put fittings on the dome of my tank, they point off at odd angles and it’s hard to connect piping to them. What can I do about this?
When I put fittings on the dome of my tank, they point off at odd angles and it’s hard to connect piping to them. What can I do about this?
Updated over a week ago

When I put fittings on the dome of my tank, they point off at odd angles and it’s hard to connect piping to them. What can I do about this?

Thermopneumatically welded fittings are the answer. We can weld any size fitting on to a curved surface and install it level for you. We can also install fittings on a tangent off the dome or sidewall if you have a special requirement for that. We can also install gussets and special pedestals and supports as needed by welding them to your tank. In some cases, you may need multiple fittings lined up and connect them to parallel piping in your process. By using our Thermopneumatically welded fittings, we can maintain a consistent angle and a precise centerline for all of your process nozzles.


Did this answer your question?